Change the IP Address and Password according to what you set before in the IP Camera web interface.If you changed the IP Address or the password of the Camera, you need to change it accordingly in the NVR by clicking on the desired IP Camera and pressing MANUAL EDIT.Enter your WiFi details (StaEssID - WiFi Name, StaPsk - WiFi Password).Click on Device Config > Network Setup > Wi-Fi.Change the Password as it is highly recommended that you add a password to your IP Camera.Click Device Config > Advance Setup > User Management.Enter the new IP Address into the browser, since the previous IP Address is not valid anymore.Change the IP Address of the camera and keep DHCP turned off so that the IP Address does not change.Click on Device Config > Network Setup > Local Setup.Enable the adobe flash player, to get the feed from the IP Camera.Enter the username and password (Default is usually Username: admin, Password: ).Enter the IP Camera Address in the web browser to access the web interface.Note down the IP Address assigned to the IP Camera by the NVR.Perform the same procedure as Step 3: Network Switch (of this instructable), in order to connect the IP Camera with the NVR.If you are using a Network Switch, connect the WiFi router to port 8 (of the network switch), and all other devices to the other ports. You also need a PC connected to the same network of the NVR in order to change the settings of the IP Camera. You would need a WiFi router with atleast 3 Ethernet Ports or else a network switch which can be connected to the WiFi Router. The Camera will disconnect if the Ethernet cable is unplugged, since it has been set to communicate solely on the Ethernet. Remember to press Enable before saving the Camera. You will also need to input the password if you have secured it with one, if not, leave it blank. Press on MANUAL EDIT, and input the IP Address of the IP Camera. You could also manually add them if you know the IP Addresses of the IP Cameras.After scanning is complete, press AUTO ADD for those IP Cameras to be saved.Press Refresh (all the properly connected IP Cameras which are supported by the NVR will show up on the list).Remove the WiFi antennas of the IP Cameras so that it communicates with the NVR solely through the Ethernet connection.The other devices can be connected to the remaining ports. If you are not using a modem, connect the NVR to port 8. Most ethernet switches connect to a modem from port 8. Power on the switch and connect the devices to its Ethernet ports.The Second Method is using a Network Switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |